| View previous topic :: View next topic |
| Author |
Message |
CathyR
Joined: 30 Dec 2009
Posts: 6
Location: Holly, MI
|
 Posted:Sun Dec 05, 2010 3:28 pm Post subject |
    |
|
| Hi all. I have a classic bay, and one of the heat exchanger tubes has fallen. When I clean the unit I use needle nose pliers and put it back, but if always falls again. How to fix this? |
|
| Back to top |
|
 |
|
|
kappel15
Super Burner
Joined: 05 Jun 2006
Posts: 6963
Location: iowa
|
| Posted:Sun Dec 05, 2010 8:26 pm Post subject |
|
|
Hi Cathyr and welcome to the forum. as you may have seen, iburncorn is in the process of starting a new forum, so you may want to get started getting a new registry over there as they are going to lock this one eventually. as far as your heat exchanger tube, you will have to have a dealer fix it. quad has a tool that they send to the dealers that they use to "press" those tubes back into position. stay warm. kap
_________________
Quadra Fire
Trained Tech.
Sante Fe
Mt. Vernon AE
kan-burn shur-kleenII kap-kleaner |
|
| Back to top |
|
|
balls of fire
Nubbin
Joined: 22 Nov 2008
Posts: 74
Location: New York
|
| Posted:Sat Dec 11, 2010 8:59 am Post subject |
|
|
If you give me your email address and I will email you the repair instructions which have pics of the repair tool and maybe you can devise something. I have one but would have to send it out to you fedex.
_________________
Classic Bay 1200FS |
|
| Back to top |
|
|
|
