| View previous topic :: View next topic |
| Author |
Message |
buster
Learner Burner
Joined: 05 Mar 2007
Posts: 20
Location: Wisconsin
|
 Posted:Fri Dec 11, 2009 11:33 pm Post subject |
    |
|
| after your answer we decided it was an auger problem and took the motor off and cleared out the auger...in putting the motor back on was wondering if the gadget from the motor that fits up onto the auger below the bushing is suppose to have 2 pegs to fit into the 2 slots under the auger...ours just had 1 peg, but there where 2 slots on the thing it was to fit into. don't know if this makes sense--- |
|
| Back to top |
|
 |
|
|
tallcorn
Super Burner
Joined: 02 Jun 2006
Posts: 9541
Location: Cedar Rapids, Iowa
|
| Posted:Sat Dec 12, 2009 12:26 am Post subject |
|
|
I think you mean the pin that keeps the motor from turning with the auger. There is probably only the one.
_________________
Countryside 3500P (pedestal version) used 8-9 yrs, 24/7 during days requiring heat. All original motors. Burns moldy corn, and pellets equally well. Burn it if you got it.
 |
|
| Back to top |
|
|
hqhorses
Joined: 18 Feb 2009
Posts: 4
Location: Clarksville Michigan
|
| Posted:Sat Dec 12, 2009 11:12 am Post subject |
|
|
| There should be 2 roll pins to drive auger. good luck |
|
| Back to top |
|
|
|
