Building Your Own Kan-Burn

From Cornburning

Jump to: navigation, search

Tools Needed:

Something to cut your PVC pipe( I used a saws all)
Something to cut your screen(I used metal snips)
Ruler or Tape measure
Dremel with sanding pad
Shop vac
Large hammer(if you don't have a hammer while creating something, your really not creating something, you'll find a use for it, I always do)

The Parts

Shopping List (*= degree turn on pvc pipe)

2 or more 55 Gal plastic drums (Should be available almost everywhere)
4ft 3" PVC Pipe
2ft 2" PVC Pipe
2ft 1 1/2" PVC Pipe
3ft of 1/4" screen
3" Y Junction(not sure of official name)
2 3" to 1 1/2" End Caps
4" to 2" Reducer Rubber Boot
45* 2" PVC bend
2" Adapter with female side on one end, and THREADS on the other(not sure of official name)
2" to 1 1/2" PCV Adapter
Shop Vac Kit with 8' of hose (WALMART)
Zip ties
Speaker Wire
PVC Cement
Goop

This Shopping list does not include a Shopvac or the tools listed above.

The Y Adapter

Mark 3" into the PVC pipe as show and cut.

The first step is to cut a three inch length of the 3" diameter PVC pipe. This will be used to connect the end cap to the bottom of the Y junction.

Making sure to de-burr the cut edges of the 3" diameter PVC, test assmeble onto the bottom of the Y and with the 3" to 1.5" reducer as shown .

The 3" pipe installed on Y

The Reducer

Now you want to take BOTH 3" to 1 1/2" end caps and use a dremel to sand the lip off of the inside of the cap to allow the 1 1/2" PVC Pipe to slide through.